A mobile phone signal repeater provides the ultimate solution in any area where cellular communications can not work well due to leak of signals.
Introduction of Mobile Phone Signal Repeater
1. Enhance Mobile Phone Signal Strength
2. Improve Communication Quality
3. Reduce Cellphone Radiation
4. Protract Cellular Battery Life
5. Economic Building Cost
6. Easy Operation
7. Easy Installation
8. Build-in Power Supply
Specification of mobile phone signal repeater
| Frequency | 2100/2600MHz |
| Frequency Range | Uplink 1920-1980MHz / 2500-2570MHz |
| Downlink 2110-2170MHz / 2620-2690MHz | |
| Gain | Uplink 60±3dBi |
| Downlink 65±3dBi | |
| Export Power | 23dBm±3dBm |
| Power Supply | Input AC100V-240V 50/60Hz 0.6A |
| Output 12V 2.0A | |
| Size | 235 x 177 x 20 mm |
| Weight | 1.2kg |
| Coverage Area | 2000m2 |
| Pass Band Ripple | ≤3dBi |
| I/O Impedance | 50Ω |
| Connector Type | N female connector |
| Noise Figure | ≤4dBi |
| Transmission Delay | ≤0.5μs |
| Ambient Temperature | -10ºC~60ºC |
| Reliability | To the GB6993-86 standard |
| Electromagnetic Compatibility | To the ETS300 694-4 standard |
| Function | a) Power supply LED denote |
| b) Export power LED denote |
Repeaters are designed to fulfill the idea of one and main principle: to fill the areas with the weak or bad signal and to amplify these low signals in order to provide you with the communication suitable for you.
1.The outside antenna receives the signal from the nearest mobile base station.
2.The outside antenna sends the received signal through the coaxial cable to the installed Repeater.
3.The repeater accepts the low signal and improves it.
4.The improved signal goes to the inside antenna through the coaxial cable.
5.The inside antenna send the improved good signal to your mobile phone.
| Item | Quantity |
| Signal booster | 1pc |
| Outdoor log periodic antenna | 1pc |
| 15m LMR300 cable with connectors | 1pc |
| Power adaptor | 1pc |
| User manual | 1pc |
| 5m LMR300 cable with connectors | 1pc |
| Indoor ceiling antenna | 1pc |
1.Please make sure the outdoor antenna is well isolated with the indoor antenna(s). They should not be on the same horizontal line. The outdoor antenna should be on the housetop, at least 10 meters far away from the indoor antenna(s), better with stairs or wall(s) in between. Put the indoor antenna(s) in the middle of room, far away from the window and door.
2.If still no signal reception after activating repeater, please check if outdoor antenna points to signal tower or elsewhere have strong signal and check if strength achieve -70dBm. Please adjust the direction of the outdoor antenna until it catches good and steady signal. To ensure the result, the outdoor signal should be as strong as possible.
3.More indoor antennas and splitters/couplers are needed for bigger indoor coverage as one indoor antenna can cover around 100-250 square meters Installation Diagram for More Indoor Antennas
